Advanced

Comparing SAP2000 and Robot Load Definitions

Compare direction and coordinate systems before plotting outputs. Use the example below to practice the review and record an output that another reviewer can reproduce.

Inputs and Prerequisites

Matched teaching models, program version notes and two independently defined load cases.

Review Workflow

  1. Model axes
  2. Loaded length
  3. Case reactions
  4. Comparison record
  1. Compare direction and coordinate systems before plotting outputs.
  2. Confirm that distributed loads act on the same length and projection.
  3. Run each case individually and reconcile total force.

Worked Example

A 5 m inclined member carries an assumed 2 kN/m vertical load along its actual length. It produces 10 kN total. If the same numeric intensity is applied over a 4 m horizontal projection instead, the resultant is 8 kN. Track which basis each model uses.

Output Checks and Common Errors

Keep actual and projected lengths in the comparison sheet. Reconcile each separate case before combining them.

Official References