Reviewing Concentrated Loads on Concrete Floor Slabs
Identify whether the slab is suspended or supported by ground. Use the example below to practice the review and record an output that another reviewer can reproduce.
Inputs and Prerequisites
Slab system identification, point loads, loaded areas and equipment layout.
Review Workflow
- Equipment feet
- Contact area
- Slab system
- Local check
- Identify whether the slab is suspended or supported by ground.
- Map equipment feet relative to joints and edges.
- Document contact pressure separately from slab response.
Worked Example
A 12 kN assumed foot on a 150 mm square plate gives 12 divided by 0.0225, about 533 kPa average contact pressure assuming full contact. That pressure does not give slab punching or flexural resistance.
Output Checks and Common Errors
Verify slab type, real bearing footprint and the location of each foot relative to joints or reinforcement.
Official References
- ACI Committee 360 on slabs on ground
Locate references for slab-on-ground design and distinguish these from suspended slab requirements.
Related Calculation Workbooks
- Slab Punching Shear and Reinforcement
A worksheet for recording slab punching stress and reviewing reinforcement options.
- Slab Punching Shear (BS 8110 RCC13)
Separates punching checks at internal, edge, corner and re-entrant supports.
- One-Way Slab Analysis and Design (BS 8110 RCC31)
Organizes spans and actions for a continuous one-way slab with a separate reinforcement view.
- Rigorous One-Way Slab Analysis (BS 8110 RCC31R)
Adds distinct service and ultimate checks, reinforcement and deflection for a one-way slab.
- Ribbed Slab Analysis and Design (BS 8110 RCC32)
Works through span actions and reinforcement for a ribbed concrete slab.
- Rigorous Ribbed Slab Analysis (BS 8110 RCC32R)
Adds dedicated serviceability and deflection tabs to the ribbed slab layout.
- Flat Slab Analysis and Design (BS 8110 RCC33)
Organizes flat slab spans, actions and reinforcement in distinct worksheets.
- One-Way Solid Slabs by Design Tables (BS 8110 RCC91)
Uses design tables for the one-way solid slab layout.
- Ribbed Slabs by Design Tables (BS 8110 RCC92)
Uses a tabulated procedure for ribbed slab design and detailing.
- Flat Slabs by Design Tables (BS 8110 RCC93)
Uses a simplified tabulated layout for flat slab checks and detailing.
- Two-Way Slabs by Design Tables (BS 8110 RCC94)
Uses a table-based worksheet for a two-way in-situ slab panel.
- Slab Punching Shear (Eurocode 2 RCCen13)
Separates punching checks at internal, edge, corner and re-entrant supports.
- One-Way Slab Analysis and Design (Eurocode 2 RCCen31)
Organizes spans and actions for a continuous one-way slab with a separate reinforcement view.
- Rigorous One-Way Slab Analysis (Eurocode 2 RCCen31R)
Adds distinct service and ultimate checks, reinforcement and deflection for a one-way slab.
- Ribbed Slab Analysis and Design (Eurocode 2 RCCen32)
Works through span actions and reinforcement for a ribbed concrete slab.
- Flat Slab Analysis and Design (Eurocode 2 RCCen33)
Organizes flat slab spans, actions and reinforcement in distinct worksheets.
- Extended Flat Slab Analysis and Punching (Eurocode 2 RCCen33X)
Combines a flat slab calculation with a dedicated punching worksheet.