Slabs on Ground and Joint Layout
Build a review record for a ground-supported slab and its joints.
Inputs and Prerequisites
Slab geometry, support and subgrade information, applied load footprints and joint layout.
Work Steps
- Inputs
- Model or detail
- Independent check
- Review record
- List uniform and local loads and where they occur.
- Map joints and supports alongside concentrations and transitions.
- Document reinforcement and intended load transfer across joints.
Worked Example or Review Exercise
Draw a plan with a point load near a joint. Identify whether the working model assumes transfer across that joint and the evidence needed to support that assumption.
Output Checks and Common Errors
Check whether the analysis assumptions match the support and joint layout. Evaluate flatness separately from structural response.
Official References
- ACI Committee 360 — slabs on ground
Use the publisher’s source to verify the scope, assumptions and applicable edition.
Related Calculation Workbooks
- Slab-on-Grade Analysis (Archive 1)
Documents slab checks for concentrated wheel and post loads, wall loads and uniform loading.
- Unreinforced Concrete Slab on Ground
A historical ACI 360R-06 slab-on-ground calculation worksheet.
- Slab-on-Grade Analysis (Archive 2)
A GRDSLAB workbook with documentation and separate wheel, post, wall and uniform load cases.