Intermediate

Structural Corrosion Inspection and Durability Review

Build a corrosion inspection record and use a worked thickness comparison to plan structural follow-up.

Inputs and Prerequisites

A drawing or member sketch, original or reference dimensions, inspection notes, measurement locations and calibrated thickness measurements.

Design and Review Workflow

  1. Exposure
  2. Observations
  3. Thickness measurements
  4. Structural follow-up
  1. Identify the member, exposure and coating condition. Mark observations on a sketch.
  2. Distinguish coating breakdown, general loss and localized pitting. Record measurement locations and the thickness used for comparison.
  3. Use the location and distribution of deterioration to scope assessment and decide where more measurements are needed.

Worked Example for a Thickness Comparison

A hypothetical steel plate has a documented reference thickness of 10.0 mm. One location reads 8.6 mm. The local difference is 1.4 mm, or 14% of the reference thickness. Record the location, instrument and repeat readings before treating the measurement as representative.

Output Checks and Common Errors

Evaluate structural resistance using the actual geometry, loading and deterioration pattern. In reinforced concrete, document cracking, delamination and evidence of exposure before choosing an investigation or repair method.

Official References